Express® Lavatory System SS-Series
SS-3/AST/STD, SS-3/AST/JUV
Installation Instructions - For Service Only
8
5/11/04
Bradley Corporation •
215-1238 Rev. C; EN 03-813
Installation Instructions
continued . . .
Step 3: Installing bowl assembly
IMPORTANT: Moving and positioning the bowl will require more than one person.
Note: Refer to Figure 5 below when installing the bowl assembly.
1. With someone to assist you, place the bowl assembly squarely onto the frame.
2. Attach the front of the bowl assembly to the frame using the four 1/4"-20 x 3/8" pan-head
screws and washers provided.
Do not tighten bolts at this time.
IMPORTANT: When bolting the bowl assembly to the frame and wall, do not
overtighten bolts. Overtightening bolts can damage the Terreon®
material.
3. After the bowl assembly is attached to the frame, use two 3/8" bolts and washers (supplied by
the installer) to bolt the bowl to the wall anchors.
4. Tighten the screws installed in procedure #2 above to secure the bowl assembly to the frame.
Do not overtighten.
Installation Instructions
continue . . .
Figure 5
3/8" BOLT
AND
WASHER
BOWL
ASSEMBLY
3/8" BOLT
AND WASHER
FRAME
1/4"-20 X 3/8"
PAN HEAD
SCREWS AND
WASHERS
BACK VIEW
