Express
®
Lavatory System - MG-Series with TouchTime
®
Control
Installation
MG-2/TT
Bradley
• 215-1480 Rev. G; ECN 13-08-025
4/9/2014
11
Installation Instructions
continued . . .
Step 6: Connecting optional hot water heater
NOTE: 240/208 or 277 voltage is required for hot water heater.
Refer to the installation manual provided with the hot water heater
for further installation information.
1. Remove the two screws from the back of the water heater.
Attach the bracket with the screws as shown in Figure 6a.
2. Hang the water heater on the rear frame member to the right
of the vertical frame member (see Figure 6b).
3. Connect the ½" flexible hose from the cold water supply
stub-out to the hot water heater inlet.
4. Connect the ½" flexible hose from the hot water heater outlet
to the supply inlet on the solenoid valve assembly.
RECOMMENDED 240V/208V
ELECTICAL BOX LOCATION, 4" x 4"
OPTIONAL 240V/208V ELECTICAL
BOX LOCATION, 2-1/2" x 4"
COLD WATER
SUPPLY
2" (51mm)
REF. ONLY
WATER HEATER EX95TMLB
MOUNTING CLIP
INLET
OUTLET
VERTICAL FRAME
MEMBER
COLD WATER
SUPPLY
HANG WATER HEATER
ON REAR FRAME MEMBER
TO THE RIGHT OF THE
VERTICAL FRAME MEMBER
REFERENCE WATER HEATER
INSTRUCTIONS FOR REQUIRED
ELECTRICAL CONNECTIONS.
FOR CLARITY,
BOWL NOT SHOWN.
WATER HEATER EX95TMLB
(269-1767), 240V/208V
5-1/4" x 9-3/4" x 2-1/16"
WATER
HEATER
BRACKET
(140-945)
SCREWS
REMOVE (2) SCREWS FROM
BACK OF WATER HEATER.
ATTACH BRACKET WITH
SCREWS AS SHOWN.
Figure 6c
Figure 6b
Figure 6a
