27
2. When cutting the driveline, follow this procedure:
a. Subtract the machine dimension (A) from the uncut driveline dimension (B) or (B-A).
This dimension determines how much too long the driveline is.
b. Add another inch (25 mm) to the dimension to be sure it doesn’t bottom out, to determine (C)
the cut off dimension.
c. Use a hacksaw to cut dimension (C) from both ends. Cut both the plastic tubes and the metal
cores.
d. Use a file to remove the burrs from the edges that were cut.
e. Assemble the 2 ends of the shaft.
f. Make sure the shaft can telescope freely. If it does not, separate the 2 parts and inspect for
burrs or cuttings on the shaft ends. Be sure it telescopes freely before installing.
FIG. 13 SHORTENING
