21
9. Release feed hopper transport latch and lower
hopper into the working position. Stow anchor latch.
10. Tighten anchor bolts to their specified torque.
11. Connect the PTO driveline:
a. Raise the input shaft guard.
b. Check that the driveline telescopes easily and
that the shield rotates freely.
c. Attach the driveline to the chipper input shaft by
depressing the lock pin, slide yoke over the shaft
and pushing on the yoke until the lock pin clicks
into position.
NOTE
Be sure the yoke with the shear pin is attached to
the machine shaft.
d. Lower the guard to cover the input shaft.
FIG. 6 HOPPER TRANSPORT LATCH
FIG. 7 ANCHOR BOLTS (TYPICAL)
FIG. 8 DRIVELINE (TYPICAL)
Aligning
Installed
4
ASSEMBLING CON’T.