6
OPERATIONS
1. Press the POWER button on the monitor for 3 seconds,
the power indicator will illuminate.
2. This equipment has been paired successfully from the
factory. If there is no display image, you will need
to pair again.
Pairing Method
: On the back of the Camera, there are 2
threaded holes with a button screw in the lower hole.
Unscrew the metal button in the lower hole and screw
it into the upper hole. Then on the front of the
monitor, press and hold the PAIRING button for 3s to
pair the frequency signal in 30 seconds. If pairing is
successful, remove the button screw from the top hole
in the Camera and screw it back into the bottom hole.
3. If the image on the LCD is unclear, adjust the
contrast, brightness and mirror by toggling the
buttons on the monitor.
o
Contrast Control:
the 5 levels of LCD contrast
can be adjusted by pressing the CONTRAST
button.
o
Brightness Control
: the 5 levels of LCD
brightness can be adjusted by pressing the
BRIGHTNESS button.
o There are four different views for the monitor.
If the image is not oriented correctly, press
the MIRROR button on the monitor to change the
orientation until it is correct.
o These different views allow you to mount the
camera and/or monitor with either right side up
or upside down and still display the image
correctly on the monitor. The image displayed
should match your rear view mirror. After
testing the unit, fully tighten the Camera
bolts.
Notice:
Press the CONTRAST button for 4 seconds to reset the
display to the factory default.
For Sales Information Please Contact
RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.
Wilmington, NC 28411
(800) 507-0482 / (910) 686-4281
