FAQs
Q. What do I do if the picture starts to break-up?
A. Turn both the receiver and the transmitter off and on again. This will reset
the units and allow it to select a different channel to use.
Q. What do I do if I only need to use one antenna when using the system?
A. Always use an antenna on both antenna ports on the transmitter and receiver. Using
only one antenna, you will damage the unit and void warranty.
Q. What if the LED indicators flash RED on the transmitter or receiver?
A. Make sure that the TX and RX are on matching frequency bands (both 2.4GHz or 5Ghz).
Check that you are supplying 8 – 18 volts DC to the unit. Reduce the distance and turn the
units off and on again. It can take up to 1 min for the TX and RX to lock.
Note the viewfinder data rate indicator flashes red to display the data rate.
Q. What if the LED indicator is blinking GREEN but I am not sending any video or
audio?
A. If the LED indicator has a quick GREEN blink, the Cobalt systems is transmitting
information and is working correctly. The GREEN blinking indicates there is no video at the
TX side. Check cable connections between the transmitter and the camera, and the
monitor and the receiver.
Composite - Black
SDI -
Blue
Component - Yellow Red Blue.
Q. What if I am using the system within recommended distance guidelines and it
is not working properly?
A. Always maintain a clear line of sight between the transmitter and receiver wherever
possible as microwave transmission doesn’t work well through walls or structures. For best
results mount the receiver as high as possible internally or externally with a clear line of
sight to the cameraman. Solid walls like brick, concrete, steel and insulated walls
dramatically reduce the range of the system.
The use of antenna splitters and high gain antennas can increase your coverage. If you
would like to discuss your environment, please contact our Sales team on
or call +44(0)845 643 2874.
Q. Can I configure the Cobalt so it can be viewed on multiple receivers at once?
A. No. The Cobalt system will only work with a single paired transmitter and receiver at
one time. You can however use up to 6 distinct sets of transmitters and receivers in the
same area without interference. Please contact our Sales team on
or call
+44(0)845 643 2874 for more info.
Q. Does the Cobalt system interfere with WiFi 802.11 A, B or G?
A. No. The system automatically scans the frequency spectrum and avoids any channels
occupied by other networks. When using more than one system in a small vicinity ensure
the distance between the receivers exceeds 15 feet (5 metres), as the receivers could
interfere with one another.
