Receiver set up
For antenna choice, please see the Boxx antenna manual.
1. Supply the receiver with 9-36v DC from a
battery or power supply via the 4 pin XLR.
Pin 4 is positive. Pin 1 is negative.
2. Plug in the video BNC.
Composite - Black
SDI -
Blue
Component -
Yellow
Red
Blue
.
3. Use 3pin XLR cables for audio left and right.
There are 2 trim pots on the back of the receiver that
will adjust the audio output. These are factory set
to a level of +4dB.
In most situations these should not be changed.
4. Use the locking toggle switch to turn the unit to
the desired frequency range. Pull the lever out to
unlock it. Centre is off. If the unit is not labelled, it will
only work in 5GHz.
We recommend 5GHz for most environments. You will
need different antennas to work in each frequency
band. (Note: 2.4Ghz has been phased out in newer
versions.)
Once on, the LED indicator will turn
RED
and then flash
RED
. The units are now searching for each other.
