Routine Service and Maintenance
4.14
New Machine Brake-in Maintenance Procedures
Do the following after the first 20 operating hours for a new machine only.
1. Change engine oil. Refer to the engine manual for the proper engine oil changing
instructions.
2.
Change engine oil filter, which is located on the left side of the - engine. Refer to
the engine manual for the proper engine oil filter changing instructions. The oil
filter is located at the front of the engine (Item 1,
Figure 4–14
).
Figure 4-14 Engine Oil Filter
3.
Replace the hydraulic filter. See Service Manual and
Figure 4–15
.
a. Remove the three bolts (Item 1,
Figure 4–15
) holding the filter cover (Item 2,
Figure
4–15
) in place.
NOTE:
Press downwards on filter cover to relieve the upwards pressure from the
spring.
b.
Remove the filter cover and spring (Item 4,
Figure 4–15
).
c.
Remove the filter element (Item 5,
Figure 4–15
) and replace with a new filter element.
d.
Inspect the filter cover O-ring (Item 3,
Figure 4–15
) for any signs of wear or damage.
Replace as needed.
e.
Reinstall spring and filter cover.
NOTE:
Make sure that the O-ring is properly seated in the filter cover.
f. Start and run the engine for about 30 seconds.
Using the hydraulic oil level dip stick (Item 6,
Figure 4–15
), check the hydraulic oil level.
Add the appropriate hydraulic fluid as needed.
Figure 4-15 Hydraulic Oil Filter Assembly
1
1
2
3
4
5
6
Summary of Contents for 700HDX
