Bowflex
®
TreadClimber
®
Service Manual
mechanical service guide
Figure 1:
Figure 2:
6.0 - REPLACEMENT oF SPEED SENSoR
Tools Needed:
• Phillips Screwdriver
NOTE: If using a powered driver, it must be on the
“LOW TORQUE” setting, otherwise it will
strip screws.
6-1
Unplug machine from wall outlet.
6-2 Wait 5-minutes after unplugging machine to
ensure there is no residual power.
6-3 Remove rear step plastic cover (8 screws), right
and left rear base plastic covers (3 screws each),
and rear base plastic cover (5 screws). See
Figures 1 & 2.
NOTE: One screw each on the right and left side
base plastic is behind the decal
(see Figure 3).
6-4 Remove rear step cover (4 screws). See Figure 4.
6-5 Looking at machine from left side, locate black
wire connected to hole in left rear drive bracket
(wire is approximately 3 3/4 inches long and is
located below left rear roller) see Figure 5 & 6.
6-6 Disconnect white cable connector from speed
sensor wire that is attached to long black wire
(see Figure 6).
AS LoNG AS THE TREADCLIMBER
®
FITNESS
MACHINE IS PLuGGED INTo A PoWERED ouTLET
AND THE PoWER SWITCH IS oN, THE uNIT IS
RECEIvING PoWER, EvEN IF THE DISPLAY IS
TuRNED oFF. ALWAYS uNPLuG THE PoWER CoRD
FRoM THE ouTLET AND WAIT 5-MINuTES BEFoRE
PERFoRMING REPAIRS oR MAINTENANCE.
7! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
Figure 3:
one screw behind decal.
