36459-6-0217
Page 39
MULTIFUNCTION REMOTE OPERATING INSTRUCTIONS
Initializing the System for the First Time
1. Remove the wall cover. Remove cover on the wall mounted
battery back-up holder.
See Figure 71
. Install the four AA
batteries into the wall mounted battery back-up holder then
reinstall the cover.
See Figure 72.
2. Install three AAA batteries into the battery bay located on the
base of the transmitter.
See Figure 73.
3. Set the wall remote slide switch to the REMOTE position.
See Figure 72.
4. Press and release the SWI button on the wall control with
a paper clip and the IFC module will beep three times to
indicate the IFC module is ready to synchronize with the
transmitter within ten seconds.
See Figure 72.
Figure 71
SWI
BUTTON
Figure 72
5. With the batteries already installed in the Transmitter,
push the On button. The Receiver will beep four times to
indicate the Transmitter’s command is accepted and sets to
the particular code of that Transmitter. The system is now
initialized.
Figure 73
Temperature Indication Display °C or °F
With the system in the OFF position, press the Thermostat Button
and the Mode Button at the same time. Look at the LCD screen
on the Transmitter to verify that a °C or °F is visible to the right of
the Room Temperature display.
See Figures 74 and 75.
Figure 74
Figure 75
