GLASS PLACEMENT
36459-6-0217
Page 37
Preparation of fireplace prior to decorative media placement
1.
DVLL60BP:
The accent glass panels are wrapped and
secured to the burner cover assembly with a cable tie for
shipping purposes. Cut the cable tie, then remove and set
aside the accent glass panels.
DVLL48BP:
The optional LK8 accent light is available. If
used, follow instructions included with the LK8 light kit for
proper installation
CAUTION
Turn off all power to the fireplace prior to changing bulbs or
servicing the controls.
2. If a liner kit has not been installed, STOP and install one
before proceeding with media placement.
3. Remove the light cover and verify that the accent light bulbs
are installed in the light bracket. These are located in the
reflective light bracket at the front of the firebox. Use gloves
or a soft cloth to verify the light bulbs are plugged correctly.
Do not handle halogen bulbs with your bare hands. Oils from
your skin will cause the bulb to burn out prematurely.
4. Install the two accent glass panels into the metal retainer
bracket located above the accent lights. The two glass
panels will be placed so they meet together at the center of
the bracket.
5. Replace the light cover over the accent lights.
6. If applicable, install Logs and Rock kit.
ACCENT LIGHT COVER
DO NOT COVER WITH
CRUSHED GLASS MEDIA
ACCENT LIGHT GLASS PANELS (DVLL60)
ACCENT LIGHT COVER (DVLL48)
CRUSHED GLASS MEDIA ALLOWED
BURNER COVER
CRUSHED GLASS
MEDIA ALLOWED
CAUTION:
PLACE CRUSHED
GLASS MEDIA IN THE RECESSED
AREA AROUND THE PILOT, PILOT
SENSOR, OR IGNITOR PROBE
DO NOT
Figure 68
7. Add the decorative crushed glass media of your choice at
this time. Crushed glass may cover the complete burner
cover, accent glass panels, and burner screen.
Place crushed glass media over the burner screen in a single
layer. Use just enough crushed glass media to mask the burner
screen (2-1/2 lbs. minimum). Additional crushed glass may be
placed over the burner cover and accent light glass panels as
shown in
Figure 68.
NOTE:
1/4” crushed glass media is required on the burner screen
and accent glass panels. 1/4” crushed glass media is optional on the
burner cover or light cover (if the LK8 accent light is not installed.)
