15 / 23
6.3.3. Delete a chase
1. Press and hold down the
PROGRAM
button for approximately 2 seconds or until the
PROG
indicator in the display flashes. Once the indicator is flashing, record mode is engaged and
you may release the
PROGRAM
button.
2. Select the
CHASE button 1-12
that you want to delete.
3. Simultaneously, press
AUTO / DEL
button then press the same
CHASE
button that you have
selected in step 2. All LEDs will flash three to confirm that the chase was deleted.
4. Repeat steps 2 and 3 to delete additional steps.
5. Press and hold down
PROGRAM
button for approximately 2 seconds to exit. A flashing
BLACKOUT
indicator, in the display, is indicative that you are out of program mode.
6.3.4. Delete all chases
1.) Flip the
power switch OFF
which is located at the rear of the unit.
2.) Simultaneously, press and hold down the AUTO / DEL and
BANK DOWN
button and flip the
power switch ON
. All LEDs will flash three times to confirm that all chases were deleted.
6.4. Chase playback
6.4.1. Manual trigger
1.) When
powered ON
, this console defaults to Manual / Blackout mode. All output will be in
blackout state until the
BLACKOUT
button is deselected. To determine blackout status, there
is an indicator light in the display that flashes when engaged and OFF when disengaged.
Press the
BLACKOUT
button so the indicator stops flashing.
2.) Press the
CHASE button 1-12
that you want to playback. The selected
CHASE
LED should
illuminate.
3.) Press the
BANK UP / DOWN
buttons, as desired, to manual step through your chase steps.
You can also manually
FADE TIME
fader if you wish to incorporate a crossfade between
steps.
4.) Repeat step 2 and 3 to manually playback additional chases.
6.4.2. Auto trigger
1.) Press the AUTO / DEL button, the
AUTO TRIGGER
indicator light will illuminate in the
display. This indicates that you are in the auto trigger mode.
2.) Press the
CHASE button 1-12
, that you wish to playback. The selected
CHASE
LED should
illuminate and begin to play. You can select more than one
CHASE
button at a time to create
a chase sequence.
