13 / 23
6. Chases
6.1. Recording chases
This product has 12 programmable chases. Each of this can store up to 240 scenes 7 steps. Please
see the below constructions for chase setting.
1.) Press and hold down the
PROGRAM
button for approximately 2 seconds or until the
PROG
indicator in the display flashes. Once the indicator is flashing, record mode is engaged and
you may release the
PROGRAM
button.
2.) Select a CHASE button 1-12, that you wish to record to. The relevant
CHASE
LED should
illuminate.
3.) Use the
BANK UP / DOWN
buttons to select the bank 1-30 that contains the scene you want
added to your chase. You can view the scene banks in the LED display by referring to the
furthest two digits to the right. You can also set your scene by using the eight
CHANNEL
faders or joystick and
PAGE SELECT
button on the fly if desired. The
PAGE SELECT
button
should be used to switch between channel 1-8 and 9-16.
4.) Press the
MIDI /REC
button to record the chase step. ALL LEDs will flash three times to
confirm that the chase step was recorded.
5.) Repeat steps 3 and 4 to record additional steps.
6.) Once you have recorded all of your steps, press and hold down the
PROGRAM
button for
approximately 2 seconds to exit. A flashing
BLACKOUT
indicator, in the display indicative
that you are out of program mode.
6.2. Recording a bank of scenes to a chase
1.) Press and hold down the
PROGRAM
button for approximately 2 seconds or until the
PROG
indicator in the display flashes. Once the indicator is flashing, record mode is engaged and
you may release the
PROGRAM
button.
2.) Select a
CHASE button 1-12
, that you wish to record to. The relevant
CHASE
LED should
illuminate.
3.) Use the
BANK UP / DOWN
buttons to select the bank 1-30 that you want add to you chase.
You can view the scene banks in the display by referring the furthest two digits to the right.
4.) Simultaneously press the
MUSIC / BKC
and
MIDI / REC
buttons to record the entire scene
bank. ALL LEDs will flash three times to confirm that the scene bank was recorded. Scenes
will record in the exact same sequence as stored in the bank.
5.) Repeat steps 3 and 4 to record additional scene banks.
6.) Once you have recorded all of your steps, press and hold down the
PROGRAM
button for
approximately 2 seconds to exit. A flashing
BLACKOUT
indicator, in the display indicative
that you are out of program mode.
