21 / 23
10.6. Delete and format files in memory stick
This operation will allow you to individually delete files from your memory stick and format the entire
memory stick all at once which erases all files in one shot. You must first install the
Usave
application
software and USB driver that was supplied with your USB MEM stick. If you have not done so, please
do so now, after this proceed to step 1 below.
1.) Plug in the USB MEM stick into a USB port on your computer.
2.) Open the
Usave
program by clicking
START
on the Windows taskbar, then click
PROGRAMS
or
ALL PROGRAMS
and click
Usave
.
3.) Click
SELECT Usave
in the upper left hand corner of the
Usave
program.
4.) Click
DITORY
. A list of files currently on the memory stick will appear in the Ustick option box.
Warning! The following procedure will format the entire memory stick. If you wish to
delete files one at a time, proceed to step 5. To format (delete) all files in one shot, click
FORMAT now. All files will immediately erase from the memory stick.
5.) Highlight the file that you wish to delete by clicking on it once.
6.) Click
DEL
. The file will delete immediately. To delete additional files repeat steps 5 and 6.
10.7. Data Transfer to DMX operator DC-192 from USB MEM stick
This operation will allow you to transfer data from your USB memory stick to the DMX operator DC-
192. You must first install the
Usave
application software and USB driver that was supplied with your
USB MEM stick. If you have not done so do so now, after this proceed to step 1 below.
1.) Plug in the USB MEM stick into the USB port on your DMX operator DC-192.
2.) Flip the DMX operator
power switch OFF
which is located on the rear of the DMX operator
DC-192.
3.) On the DMX operator DC-192, simultaneously press and hold down the
FIXTURE 8
,
FIXTURE 9
and
SCENE 2
button and
power ON
. If
FAIL
appears in the controllers display, it
means that the memory stick was not installed properly.
(Note: If
noP
appears, it means that there are no files currently stored in the memory stick.
You must first write your file to the memory stick by using the
Usave
software program. If
FL0X
appears, X represents file number 1-8 within the memory stick, it means files are
already stored to that folder and you can use
BANK UP / DOWN
buttons to access other
folder currently on the stick this time.) Select the folder you wish to upload into the controller.
For example, if you have your programs stored in folder
FL01
then leave it set on the folder
and proceed to the next step.
4.) Simultaneously press the
PROGRAM
button and the
SCENE
button that corresponds with the
folder that you wish to store to within the memory stick. For example if you want to store folder
4 then simultaneously press the
PROGRAM
button and
SCENE button 4
. (
SCENE buttons
