5-9
Section 5 • Care & Maintenance
345 Conquest
Never start or run your outboard (even
momentarily) without having water circulating
through the cooling water intake holes in the
gear case. This will prevent damage to the
water pump (running dry) or overheating of
the engine.
!
CAUTION
Engine
Protecting your engine’s vital moving parts from
corrosion and rust caused by freezing of trapped
water or excessive condensation due to climatic
changes is very important. Freezing water in the
engine can cause extensive damage to the internal
moving parts. Internal engine parts can also be
affected by rust due to lack of proper lubrication
• Replace the engine oil and filter, running the
engine to drain out as much old oil as
possible.
• Flush the engine with fresh water using flush
muffs or a similar device attached to the raw
water pickup.
• Let all water drain from the engine.
• Fog the engine while it is running. Spray until
it stalls.
• Run fuel which has been treated with
conditioner and stabilizer through the
engine.
• Replace lower unit gear oil. Check for
moisture in old oil, a sign of deteriorating
seals.
• Remove the prop and grease the shaft and
threads.
• Treat all grease fittings with the recommended
lubricant.
Periodically check the zinc buttons (anodes)
installed on the lower unit of your engines.
Replace if half or more of the zinc is missing.
NOTICE
Fill the tank completely (100% ) full and add
fuel stabilizer and conditioner, following the
manufacturer’s recommendations, to provide fuel
stability and corrosion protection.
Tank(s), hoses, and fuel pumps should be treated to
help prevent the formation of varnish and gum.
Temperature extremes will cause condensation to
accumulate in an empty or partially filled fuel tank
leading to fuel contamination and/or premature wear
of your system.
Fuel System
Pay particular attention to the information
provided in “Ethanol-Blended Fuel” in section
3 of this manual.
NOTICE
Electrical System
• Check all connections and tighten if
necessary.
• Spray all connections with an anti-corrosion
spray.
• Lightly lubricate the exterior of the engine or
polish with a good wax.
• Check engine mount bolts. Ensure that they
are torqued to 55 ft/lbs.
In addition, be sure to follow all recommendations in
your engine manufacturers operation manual.
Battery
Engine and house electrical systems on our boats
have become increasingly more complex and are
reliant on a good source of power. The house source
of power typically comes from a battery bank
comprised of two or three batteries in parallel. The
charging source for the batteries while away from
the dock is the engines; or if equipped a generator a
Follow the manufacturer’s recommendations for
long term storage of your battery(s).
NOTICE
Summary of Contents for CONQUEST 345
