MAINTENANCE CHECKLIST
Maintenance
Benefit
Procedure
Service Interval
Inspect trigger performance
Ensure trigger system is in
proper working order
Refer to Tool Operation
Check section in this manual
Daily
Drain condensation from air
compressor tanks and air
filters daily or after each use.
Prevents accumlation of
moisture that can impede tool
performace
Open drain cock on tanks
and air filters and drain all
condensate
Daily
Clean magazine assembly
Prevents accumlation of
debris that could cause a jam
Blow clean with compressed air Daily
Clean nose, door, and
contact arm area
Prevents accumulation of
debris that could cause a jam
or malfunction
Blow clean with compressed air Daily
Ensure all fasteners remain
tight
Prevent loose parts
Tighten all fasteners with
appropriately sized hex
wrench
Weekly
Check/clean air inlet air filter Maintains proper air flow to
engine for peak performance.
Remove end cap and use
compressed air blow gun to
blow filter clean. Replace filter
as required.
25,000 Fasteners, or monthly
- if used in dusty location
Replace no-mar tip
Prevents marks in softwood
applications
Remove worn no-mar tip and
replace with a new tip (a spare tip
is located on the magazine)
25,000 Fasteners
Replace piston/driver
assembly
Maintains consistent drive
quality
Refer to replacement part kit
instructions
150,000 Fasteners
Replace O-rings
Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace bumper
Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace headvalve
Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace engine cylinder
Maintains engine for peak
performance
Refer to replacement part kit
instructions
500,000 Fasteners
-14-
