13
Adjust the cutting speed so that the sparks go
through the work piece and out the bottom of
the cut.
After the cutting arc starts, slowly start moving
the torch across the work piece.
Note:
Always start the Arc on a material edge
or drill a small hole in the work piece to start
Arc.
At the end of the cut pause to allow the
plasma to sever the last part.
Regularly inspect your consumables for wear.
Replace when excessive wear is apparent.
If the sparks a blown out toward the torch or
at a great angle below the work piece, reduce
the cutting speed.
11
14
12
15
13
SET UP P40 Inverter DC Plasma Cutter- continued
Note:
Pictures may vary from your machine model
