13
Press the trigger. This will feed the wire
through the torch. Release button when wire
appears at the end of the torch.
NOTE:
Make sure your torch is layed out
straight
Plug machine into 240V and
switch to the ON position on the
back of machine.
Trim wire to the end of the nozzle.
Refer to settings chart on the front of the
machine for suggested machines settings
and material thickness.
Set The welding Voltage and
Wire Speed according to chart
Remove nozzle (A) and
tip (B) from torch.
A
B
Re install tip over the wire and tighten,
Do NOT over tighten, or you may damage
the tip holder and re-attach nozzle to
torch.
NOTE: Make sure your torch is
layed out straight
Note:
Pictures may vary from your machine model
9
11
13
14
15
12
10
Connect earth clamp to the work
piece ensuring that the clamp
makes good contact with bare metal.
8
