12
MACHINE SET UP GASLESS MIG WELDING
Note:
Pictures may vary from your machine model
AT
TENTION
Recommend using Gasless 0.8mm x 0.9kg
THIS MACHINE ONLY
WORKS WITH
GASLESS MIG WIRE
0.9
K
g S
po
ols O
NLY
Open the side door of the machine.
Release the Wire Feed Tensioning
Knob by pulling it down.
Take the end of the wire and feed
into the Guide tube until it passes to
the Inlet Tube, approx 100mm
Remove the Spool Hub Nut and
place spool of wire on Spool Hub.
Remove the Drive Roller Cover. Check
the Drive roller is matched to the wire
size for the job
Note:
Correct wire side
on roller to face out off machine when
fitting.
Then replace the Drive Roller
Cover. before feeding the wire
See Page 14 for drive roller
size and type.
Put down Wire Tensioning Arm so it
locks into position, and turn the Wire
Feed Tensioning Knob to gently
tighten.
Replace Spool Hub Nut and adjust
firmly - without too much pressure.
Note:
Wire to roll from over top of
spool into wire feeder
Ensure you hold the spool and check
tension to stop wire spool unraveling
1
5
2
3
4
7
6
Roller Groove
V-knurled - Gasless Wire
Drive roller
size (mm)
