Configure DTMF mode, RTP mode, RFC2833 mode,
H245-string mode and H245-signal mode;
Configure permission for no-registered call allow to
initiate call without net gate register;
Early245 configuration which means that when initiating a call, the
225 message transmission begins at the same time with 245 message transmission the
default is Disable;
Configure enable/cancel register;
Configuration for transferring 245 message package to 225
message package;
Configure H323 to run the talking only by G.7231 encode the
default is Disable;
Configure the phone use H323 protocol as default call
protocol;
Configure quick start mode to start H323 call;
Configure multiplexing of logical channel, the default is
Disable;
Configure the phone can receive IVR, such as the voice prompt,
dialling of PSTN color ring;
Configure GK backup and enable GK detecting and auto-swap functions, the phone will
automatically swap to GK backup server when there is no response from default GK and
test the default GK if the default GK recovers response the phone will automatically
swap to the default GK.
Configure GK backup server IP;
Configure server port for GK backup;
，
，
，
，
，
；
，
Configure ID for GK backup;
To access certain services such as voice mail or interactive telephone system, it is
necessary to use tone dialing. When your phone is set to the pulse mode, DTMF dialing is
available
.
temporarily
Press the
button while the phone is in the pulse dial mode. Your phone is converted to
the tone dial mode temporarily.
When you hang up the call, the mode returns to the pulse mode.
Tone Dialing Switchover
You can page the handset from the base unit. Using this feature, you can locate the lost
handset.
Press the
button on the base unit. All handsets registered to the base will ring for
about 30 seconds.
To stop paging, press the
button on the base or any button on the handset.
Note
:
If a call comes in while the handset is being paged, the handset stops paging and the bell will ring.
Paging
PAGE
During a conversation, the
button is used to end the call for making a new call or to
local transfer a call to another extension if under PABX.
To flash, simply press the
button while the line is engaged.
Result:
The display shows
.
Registered Recall
C/R
C/R
f
PAGE
16
39
