If your vehicle is a Nissan or Toyota,
follow this mounting instruction: Use the
screw holes marked T (Toyota), N
(Nissan) located on both sides of the unit
to fasten the unit to the factory radio
mounting brackets supplied with your
car.
Fasten the unit to the factory radio
mounting brackets. Align the screw holes
on the bracket with the screw holes on
the unit, and then tighten the screws
(5x5mm) on each side.
Note: the outer trim ring, sleeve and
the metal strap are not used for
method B installation.
2. DIN Rear-Mount (Method B)
the supplied hardware (Tapping Screw
(5x25mm) and Plain Washer) to attach
the other end of the metal strap to a solid
metal part of the vehicle under the
dashboard. This strap also helps ensure
proper electrical grounding of the unit.
10. Reconnect the cable to the vehicle
battery's negative (-) terminal. Then
replace the outer trim ring and install the
front panel.
1. Make sure the ignition is turned off,
and then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Remove the metal strap attached the
back of the unit (if attached).
3. Press the release button to remove the
front panel.
4. Lift the top of the outer trim ring, then
pull it out to remove it.
5. Insert both of the supplied keys into
the slots at the middle left and right sides
of the unit. Then pull the unit out of the
dashboard.
Removing the unit
BV4450T User’s Manual - page 5
