AM 259777 Rev.00 PDF
August 14, 2001
13
System Installation Instructions
Connecting the Acoustimass
®
module to the media center
Connect the Acoustimass module to the media center with the audio input cable (Figure 10).
Note:
Be sure that each connector is fully inserted into each jack.
1.
Plug the small black multi-pin connector (flat side facing up) into the SPEAKER ZONES
jack labeled “1” on the back of the media center.
2.
Insert the telephone-style RJ-45 connector on the other end of the audio input cable into
the AUDIO INPUT jack on the Acoustimass module. Align the connector at the angle
shown in Figure 10. When properly connected, it should lock in place.
Note:
Refer to “Setting up a second listening zone” on page 23 for information on connecting
a second zone.
Figure 10
Acoustimass connection to
media center
CAUTION:
Do not place strain on the audio input cable, especially on the connection to the
Acoustimass module. Placing excessive strain on the cable may cause damage to the cable
connection at the Acoustimass module. When disconnecting the cable from the Acoustimass
module, be sure to press the tab on the connector.
TV
SENSOR
IR
EMITTER
SERIAL
DATA
SPEAKER
ZONES
1
2
1.1A
33V
DC POWER
AM
FM
75
ANTENNA
OPTICAL
OPTICAL
INPUT
OUTPUT
AUDIO OUTPUTS
DIGITAL
DIGITAL
R
L
RECORD
DIGITAL
R
L
DIGITAL
R
L
DIGITAL
R
L
DIGITAL
R
L
TAPE
AUDIO INPUTS
AUX
VCR
TV
VIDEO INPUTS
COMPOSITE
S-VIDEO
COMPOSITE
S-VIDEO
VIDEO OUTPUTS
OUTPUTS TO
CUBE SPEAKERS
AUDIO
INPUT
POWER
FRONT
SURROUND
100-120/200-240V AC
50/60 Hz
350W MAX.
L
C
R
L
R
1
Audio input cable
Acoustimass module
connector panel
Note:
Press tab to release cable connector.
When fully inserted into the jack, the connector
locks in place.
