Bose ControlSpace AMS-8, Safety Instructions & Installation Manual

Page: 10 / 256

10
En
gli
sh
1
2 3
Before configuring the ControlSpace
®
AMS-8, one needs to select a number for each wall controller (1..8), this
is normally done the first time the wall controller is connected to the system rack. A few seconds after the wall
controller has been connected to the system rack, the Firmware version is displayed on the LCD screen, followed
by “Select WC..”. Use the channel buttons to select the appropriate number and confirm this choice by pressing
the volume down (-) button. If multiple wall controllers need to be used to control the same room, one should
select the same number on these wall controllers as well. In a situation like this, all wall controllers need to be
connected to the same rack frame.
If a wall controller already has a number then it can be altered as follows:
1. Switch the wall controller off (press the channel down (-) button as many times as needed
until the wall controller is switched off)
2. Press and hold the channel down (-) button
3. Press the volume up (+) and down (-) buttons at the same time (After the LCD screen has displayed
the Firmware version it displays the actual number, e.g. “WC2”).
4. Now you can use the channel buttons to select the appropriate number and confirm this choice by
pressing the volume down(-) button in the same way as before.
If the system consists of two or more ControlSpace
®
AMS-8 racks, all racks use numbers (1..8).
For the first rack numbers 1..8 are used for output channels 1..8, for the second rack output channels 9..16 up to
the tenth rack for outputs 73..80.
Changing room settings using the wall controller
For the room where the wall controller is installed one can adjust the audio settings using the hidden menu in
the wall controller. Follow the procedure below to enter this menu:
1. Switch the wall controller off (press the channel down (-) button as many times
as needed until the wall controller is switched off)
2. Press and hold the volume down (-) button
3. Press the channel up (+) and down (-) buttons at the same time
In the hidden menu the following functions can be set or altered:
a. default channel b. bass level c. treble level
d. dynamic EQ e. Bose speaker EQ f. maximum volume level
g. paging volume level h. delay i. default volume level
The channel buttons allow you to scroll through the menu items whilst the volume buttons allow you to change
the settings for the selected item.
To leave the hidden menu, press the channel up (+) and down (-) button at the same time.
3.3 Wall Controller configuration
1. LCD SCREEN
2. VOLUME KEYS
3. CHANNEL KEYS
3. System Installation