Bosch XQG100-WDU285H80W, User Manual And Installation Instructions

Page: 13 / 56

Installation and connection
en
13
ATTENTION!
If residual water in the appliance
freezes, this may cause damage to
the appliance.
▶
Do not install or operate this appli-
ance anywhere that is liable to ex-
perience frost or outdoors.
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
▶
Tilt the appliance carefully.
▶
Transport the appliance in an up-
right position.
Installation loca-
tion Requirements
Base Secure the appli-
ance with fixing
brackets
→
Page 30 .
Wooden joist
floor Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Kitchen unit Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
cent cabinets.
Required niche
width: 60 cm.
Installation loca-
tion Requirements
Against a wall Do not trap the
hoses between
the wall and the
appliance.
4.4 Removing the foam block
To prevent damage during transit, the
appliance is fitted with a foam block,
which must be removed before using
the appliance for the first time. If in
doubt, contact a specialist to have it
removed.
WARNING
Risk of injury!
When the appliance is tilted, the ap-
pliance may tip over.
▶
Tilt the appliance carefully.
▶
Do not tilt the appliance on your
own.
ATTENTION!
If the foam material is not removed, it
can cause damage to the appliance
when it is operated.
▶
Before starting up the appliance,
remove the foam block in its en-
tirety.
Note:
Remove the foam block first
before you remove the transit secur-
ing devices.