Bosch WTG865H4UC, Use And Care Manual / Installation Instructions

Page: 25 / 48

25
Loading the laundry
9
WARNING
RISK OF EXPLOSION
Do not dry laundry that has ever been in contact
with solvents, oil, wax, grease or paint (e.g. nail
varnish remover, stain remover, cleaning solvent,
etc.).
1.
Check lint filter.
The filter should be cleaned after or before every
drying process. Cleaning the filter reduces the drying
time and saves energy.
~
Cleaning the lint filter; Page 36
2.
Load the laundry into the drum and close the door.
Tip:
If the door has not been closed properly, the dryer
will not start.
Tips
After loading, close the door carefully so as not to trap
any items between the door and the rubber seal. The
door should be closed until a click is heard.
Foreign objects left in the drum may damage laundry.
Before inserting any laundry, check to make sure no
foreign objects are in the drum.
Recommended Load Size
Recommended maximum load size can be found in the
program selection table in this manual.
~
Program selection table; Page 32
Load the laundry
Place laundry in the empty drum. Put each piece of
laundry into machine separately.
For best results the laundry should be sorted according
to type of laundry and desired degree of drying.
~
Sorting the laundry; Page 31
~
Program selection table; Page 32
~
Level Adjust; Page 33
Starting the program
1.
Switch on the appliance. Rotate program selector to
the desired program. Select the program which
corresponds to the laundry in the dryer from Program
selection table.
~
Program selection table; Page 32
The
Start/Pause
indicator light starts flashing.
2.
Press the
Start/Pause
button. Indicator lamp lights up
and the cycle starts.
During the cycle, the display area indicates the
estimated remaining time and, after starting the drying
cycle, the cycle duration and the symbols for the cycle
progress stay lit.
NOTICES
▯
If you want to protect the cycle against inadvertent
adjustment select the
Child Lock 3 sec.
.
~
Child
Lock 3 sec.; Page 34
▯
If
é
indicator lights up, clean the lint filter and/or
Condenser.
~
Cleaning the lint filter; Page 36 ,
~
Cleaning the Condenser; Page 37
▯
If
DR
indicator lights up, check the drain hose and
its connections for restrictions and if the tank needs
to be emptied.
~
Maintenance of drain
hose; Page 38
3.
If required, select
Low Heat
by pressing the button.
~
Low Heat; Page 33
4.
If required, select
Wrinkle Block
by pressing the
button.
~
Wrinkle Block; Page 33
L