36
Cleaning the lint filter
Dirty filters prolong the drying time and increases energy
consumption.
The filter should be cleaned before or after each drying
process.
If
é
indicator lights up during a drying program, clean
the filter immediately.
Tip:
The program is interrupted automatically.
To clean the lint filter:
1.
Turn the Program Selector to switch off the appliance.
9
CAUTION
The inside of the door heats up during the drying
process. The drum, the door and the laundry may
be hot.
2.
Open the door.
3.
Pull out filter.
Remove the lint from the lint filter opening and area
below. Ensure that no lint falls into opening below.
4.
Open the filter.
5.
Remove lint (run hand over filter).
NOTICE:
Severely dirty or clogged lint filter should be
rinsed under warm running water.
The filter must be dried thoroughly before being
placed back into dryer.
6.
Close the filter and re-insert it.
7.
Close the door.
Summary of Contents for WTG865H4UC
Page 1: ...en us Use and Care Manual Installation Instructions Dryer WTG865H4UC ...
Page 45: ......
Page 46: ......
Page 47: ......