TUMBLE DRYER
r120085e -15/13
04.99
Error
no.
Test / Procedure
Possible cause
Error display
18
Starts by itself when
switched on.
Appliance was switched off
during a drying cycle.
Customer information:
If the appliance switches off
and subsequently switches
on again while a drying
programme is running, the
appliance is starting by itself
in order to terminate the
programme which was
started.
VI.
SUPPLEMENTS
1.
Power and control module
Changed software mask 3 (software version V 3.00 is indicated on the processor).
⇒
Reduced heat output in the time programme.
⇒
Empty drum or dry washing identified within 5 minutes (–2 % relative humidity).
⇒
Clocking at reduced heat output.
⇒
No stop function when start button pressed again.
2.
Spark discharge between belt clamping device and motor connector plug
Drive belts were occasionally manufactured with an insufficient carbon content, resulting in
a static charge build-up between the belt wheel and drive belt. In these cases the drive belt
(Mat. no.: 15 4142) must be replaced.
3.
Improvement in temperature control in the heat registers
All heaters will receive a new thermal cut-out (modified design). Thermal cut-outs
(Mat. no.: 15 4132) and NTC (Mat.: no. 15 4186) are no longer available as spare parts.
If required, heaters in appliances with customer-service index /01 should be completely
replaced.
4.
Increase to customer-service index /02
Individual parts of the heater (NTC and thermal cut-out) are available again as spare parts.
