en
Troubleshooting
44
Fault
Cause and troubleshooting
Water is leaking out at
the water inlet hose.
Water inlet hose is not correctly/securely connected.
1.
Connect the water supply hose correctly.
→
"Connecting the water inlet hose", Page 14
2.
Tighten the screw connection.
Water is leaking out at
the water outlet hose.
The water outlet hose is damaged.
▶
Replace the damaged water outlet hose.
Water outlet hose is not connected correctly.
▶
Connect the water outlet hose correctly.
→
"Water outlet connection types", Page 14
Fluff on the laundry.
Fluff has accumulated in the drum.
▶
Run the
Drum Care
programme without any
laundry or detergent.
Water inlet noise dur-
ing the drying phase.
Drying phase requires water.
1.
Not a fault.
2.
Make sure that the water tap also remains open
during the drying phase.
Drying programme
does not start.
Door is not closed.
1.
Close the door.
2.
Press
Start / Reload
to start the programme.
No drying programme is selected.
▶
Select a suitable drying programme.
→
The laundry is too
damp.
Unsuitable programme for the type of fabric.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
1.
Remove the laundry from the drum as soon as the
drying programme has finished.
2.
Spread the items of laundry for cooling.
Unsuitable dryness level set.
Drying target not adjusted.
Load too small.
Moisture sensor dirty.
Water tap is closed during the drying phase.
▶
Make sure that the water tap also remains open
during the drying phase.
