en
Positioning and connecting
20
■
No multiple plugs/couplings or
extension cables are used.
■
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used:
z
.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Algodón/Algodão (Cottons) 90°C
programme the first time
without
laundry.
Note:
■
The appliance must have been
installed and connected properly.
■
Never switch on a damaged
appliance.
1.
Insert mains plug.
2.
Turn the water tap on.
3.
Close the door. Do not load any
laundry.
4.
Select the
Algodón/Algodão
(Cottons) 90°C
programme.
5.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
Dispenser II.
7.
Add standard detergent to
Dispenser II according
to manufacturer’s instructions for
light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
8.
Close the detergent drawer.
9.
Select
A
Inicio/Pausa + Carga
(Start/Reload)
.
10.
When the programme ends, turn the
programme selector to
Û
(Off)
.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
3.
Drain any residual water.
4.
Disconnect the appliance from the
mains.
5.
Remove the hoses.
6.
Empty the dispensers.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
Summary of Contents for WNA13400ES
Page 55: ...6 ...
