Bosch WLK24261BY, Instruction Manual And Installation Instructions

Page: 29 / 42

Faults and what to do about them.
en
29
Detergent solution is not
drained.
■
– – – (Rinse stop = without final spin cycle) selected?
~
Page 21
■
Clean the drain pump.
~
Page 26
■
Clean the outlet pipe and/or drainage hose.
Water not visible in the
drum.
Not a fault – water below the visible area.
Spin result not satisfac-
tory.
Laundry wet/too damp.
■
Not a fault – the unbalanced load detection system has interrupted the spin
because the laundry is unevenly distributed. Distribute small and large
items of washing in the drum.
■
Too low speed selected?
Spin cycle activated sev-
eral times.
Not a fault – unbalanced load detection system adjusts imbalance.
The programme takes
longer than usual.
■
Not a fault – unbalanced load detection system adjusts imbalance by
repeatedly distributing the laundry.
■
Not a fault – foam detection system active – a rinse cycle is switched on.
■
Not a fault – VoltCheck active
~
Page 24
The programme duration
changes during the wash
cycle.
Not a fault – the programme sequence is optimised for the particular wash pro-
cess. This may result in changes to the programme duration in the display field.
Residual water in the care
product dispenser.
■
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.
Odours in the washing
machine.
Run the
i ü
Cottons 90 °C programme without laundry. Use standard
detergent for this.
N
symbol flashes. Foam
may escape from the
detergent drawer.
Too much detergent used?
Mix one tablespoonful of fabric softener with 1/2 litre water and pour into com-
partment II (Not for outdoor fabrics, sportswear fabrics or those made with
down.)
Reduce detergent dosage for the next wash cycle.
Intense noise, vibrations
and "wandering" during
spinning.
■
Appliance aligned? Level the appliance.
~
Page 37
■
Appliance feet fixed? Secure appliance feet.
~
Page 37
■
Transportation protection devices removed? Remove transportation bolts.
~
Page 34
Display panel/indicator
lights do not function
while the appliance is run-
ning.
■
Power failure?
■
Fuse tripped? Switch on/replace the circuit breakers.
■
If the fault occurs repeatedly, call the after-sales service.
~
Page 30
Detergent residue on the
laundry.
■
Occasionally, phosphate-free detergents contain water-insoluble residue.
■
Select
O
Rinse or brush the laundry after washing.
The colon on the Ready
in display : is flashing.
Mains voltage too low
~
Page 24
The single dot (
.
) flashes. Undervoltage during the washing programme causes an extending of the wash
programme.
~
Page 24
Faults Cause/Remedy