en
Troubleshooting
56
Errors
Cause
Troubleshooting
The spin cycle runs several
times.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
The programme duration
changes during the wash
cycle.
The programme operation is
optimised electronically. This
may change the programme
duration.
▶
Not a fault – no action required.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
▶
Not a fault – no action required.
No water is visible in the
drum.
Water is below the visible
area.
▶
Not a fault – no action required.
Drum jerks after the pro-
gramme starts.
This is caused by an internal
motor test.
▶
Not a fault – no action required.
Residual water is present in
the compartment .
Insert in compartment is
blocked.
▶
"Cleaning the detergent drawer",
Vibrations and movement of
the appliance whilst spinning.
Appliance is not correctly
aligned.
▶
"Aligning the appliance", Page 16
The appliance feet are not
fixed.
▶
Secure the appliance feet.
"Aligning the appliance", Page 16
Transit bolts have not been re-
moved.
▶
Drum does not turn, water
does not flow in.
Load detection is active.
▶
Not a fault – no action required.
Note:
The load detection can take up to
two minutes.
