en
Appliance settings
44
Caution!
Damage to the appliance
Cleaning agents and agents for
pretreating laundry (e.g. stain removers,
prewash sprays, etc.) may cause
damage if they come into contact with
the surfaces of the washing machine.
Do not allow these agents to come into
contact with the surfaces of the washing
machine. If necessary, immediately wipe
away spray residue and other residues/
droplets with a damp cloth.
Notes
■
When dosing all detergents,
cleaning aids and cleaning agents,
always follow the manufacturer's
instructions.
■
If detergent is dosed manually, do
not dose any additional detergent via
intelligent dosing (then set intelligent
dosing to "off"); this prevents
overdosage and foaming.
■
Dilute viscous fabric softener and
fabric conditioner with water to
prevent blockages.
Dosing and adding detergent:
1.
Pull out the detergent drawer.
2.
Add the dosage to the left-hand
compartment depending on the
following:
– Soiling
– Water hardness (ask your water
supply company)
– The amount of laundry
– The manufacturer's instructions
3.
Close the detergent drawer.
Q
Appliance settings
Appliance settings
You can change the following settings
in the control and display panel:
■
The volume of the information signal
(e.g. at the end of the programme),
■
The volume of the operating signals,
■
The brightness of the operating and
display field,
■
Select/deselect the memory function
for drum care.
You will need to activate the setting
mode in order to change these settings.
Activating the setting mode
1.
Switch on the appliance. The
settings for the current programme
are displayed.
2.
Touch the control panel
œ
.
The setting mode is activated and the
displays for the information signals
U
and the preset volume light up.
You can now change the settings:
Changing the signal volume
To do this, touch
N
or
M
on the control
panel until the required adjustment
value for the volume of the
information
signals
appears:
Adjustment values:
Exit setting mode or:
Touch
œ
again. The display for the
operating signals
C
and the preset
volume light up.
Touch
N
or
M
to change the
adjustment value (as above).
Exit setting mode or:
0
off
1
quiet
2
Medium
3
loud
4
very loud
