en
Sensors
30
Programme end
End
appears in the display panel and
the indicator lamp of the Start button is
off.
Removing laundry/switching
off the appliance
1.
Open the door and remove the
laundry.
2.
Turn the program selector to
Off
.
The appliance is switched off.
3.
Turn off the tap.
Note:
Not required for Aqua-Stop
models.
Notes
■
Do not leave any items of laundry in
the drum.They may shrink in the next
wash or discolour another item.
■
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■
Wipe the rubber seal dry.
■
Leave the door and detergent
drawer open so that any residual
water can evaporate.
■
Always wait until the program ends,
as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
■
If the display panel goes off at the
end of a program, the energy-saving
mode is active.Press any button to
activate the panel.
H
Sensors
Sensors
Automatic load sensing
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Note:
Place large and small items of
laundry evenly in the drum.
~
Page 36
VoltCheck
depending on the model
The automatic voltage control system
detects an unauthorised voltage under-
usage. The colon on the Ready in
display is flashing.
~
Page 21
Once the supply voltage is stable again,
the colon of the Ready in display lights
up (Normal mode).
The detected voltage under-usage is
indicated in the further program
sequence by all three points lighting up
in the display.
Note:
Voltage under-usages can for
example result in program extensions
and/or a non-satisfactory spin result.
