en
Positioning and connecting
34
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly
installed
and
connected
(from
~
Page 28
).
■
Never use a damaged machine.
Inform the after-sales service.
~
Page 27
1.
Check the washing machine.
2.
Connect the mains plug.
3.
Turn on the tap.
4.
Switch on the appliance.
5.
Close the washing machine door (do
not load any laundry).
6.
Select the
Cottons 90 °C
programme.
7.
Open the detergent drawer.
8.
Pour approximately 1 litre of water
into compartment
II
.
9.
Add standard detergent to
compartment
II
according to
manufacturer’s instructions for light
soiling.
Note:
To prevent foaming, only use
half the recommended amount of
detergent. Do not use detergents
designed for woollens or delicates.
10.
Close the detergent drawer.
11.
Press the
Start button
.
12.
Switch off the appliance when the
programme has finished.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
3.
Drain the remaining detergent
solution.
4.
Disconnect the washing machine
from the mains.
5.
Remove the hoses.
Installing the transport locks:
1.
Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2.
Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
■
The transport locks
must
be
removed.
■
To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment
II
and start
the
Drain
programme.
