en
Operating the appliance
16
■
The preset spin speed.
Change the programme
default settings
You can use the displayed programme
default settings or adjust them.
To do this, repeatedly press the
corresponding button until the required
setting is displayed. Then press the
Start button to start the programme.
Note:
All buttons are sensitive and only
need to be touched lightly. If the buttons
are held for longer, the appliance
automatically runs through the setting
options.
The settings are activated without
needing to be confirmed.
They are not saved after the appliance
is switched off.
Programme default settings
~
Page 13
Programme overview from
~
Supplementary sheet for the installation
and operating instructions
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the progress
of the programme.
The button indicator lamps light up if a
setting is activated.
The settings are not saved when the
appliance is switched off.
Additional settings
~
Page 14
Programme overview from
~
Supplementary sheet for the installation
and operating instructions
Placing laundry into the drum
:
Warning
Risk of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse these items of laundry
thoroughly beforehand.
Notes
■
Mix items of laundry of varying sizes.
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual laundry
items may cause an unbalanced
load.
■
Observe the maximum indicated
load. Overfilling adversely affects the
washing result and encourages
creasing.
1.
Unfold pre-sorted items of laundry
before placing them in the washing
drum.
2.
Make sure that no items of laundry
are trapped between the washing
machine door and the rubber seal,
and close the door.
The indicator light on the Start button
flashes, and the default settings for the
programme appear continuously on the
display panel. Changes may be made
to the default settings.
