Bosch VLE 21 Series, Repair Instructions

Page: 42 / 52

1 689 975 224 2013-11-06
|
Robert Bosch GmbH
42 | VLE 21xx | Settings en
7.2.2 Adjusting spindle guide
Contents Adjusting spindle guide
Applicability VLE 2130 EL, VLE 2140 EL
The spindle guide must be adjusted after setting the
overtravel.
1. Tighten the hose clamp (Fig. 15, Pos. 1) at the
spindle guide (Fig. 15, Pos. 2).
Fig. 15: Adjusting spindle guide
1 Hose clamp
2 Spindle guide
i
Continue tightening the hose clamp until the spindle
attains a moment of resistance of
22 Nm . Check this
with a torque wrench at the end of the spindle.
2. Perform one lifting operation.
3. Check and if necessary correct the setting.
7.2.3 Adjusting belt tension
Contents Adjusting tension of ribbed belt
Applicability VLE 2130 EL, VLE 2140 EL
Special tools and
other items
Vibration meter
The ribbed belt should be checked every six months
and if necessary adjusted as follows:
1. Detach the cover.
2. Cause the ribbed belt to oscillate by tapping or
plucking.
Fig. 16: Plucking ribbed belt
3. Use a vibration meter to measure the frequency of
the oscillations (in hertz).
Fig. 17: Measuring frequency
i
If the ribbed belt tension is correct the frequency
will be
220–240 Hz .
4. Re-tension if necessary with the tensioning bolt
(between the motor and column).
Fig. 18: Re-tensioning with bolt
5. Check the tension again after several lifting and
lowering operations.