Bosch VJD-3000, Installation Manual

Page: 15 / 34

Connection
Connecting monitors
You must connect a suitable monitor to the decoder. The unit provides two monitor outputs.
Simultaneous use of both outputs is possible once you have set the video standard to PAL or
NTSC.
Notice!
The default setting for the video standard is PAL. Display may not work properly if you
connect other than PAL monitors without adapting the corresponding setting.
Make sure that the cables used do not exceed the maximum length of 30 m (98 ft).
1.
Connect an analog video monitor (PAL/NTSC) to the BNC socket VIDEO OUT using a
video cable (75 ohm, BNC plug).
2. Connect an HDMI-compatible computer monitor to the HDMI socket using an HDMI cable.
Note: No audio is supported via the HDMI connection. Use the audio ports if you need
audio transmission.
Using an HDMI-DVI adapter, you can also connect a DVI monitor via the HDMI socket.
5
5.1
VIDEOJET decoder 3000 Connection | en 15
Bosch Sicherheitssysteme GmbH Installation Manual 2013.08 | V3 | F.01U.281.923