EX65 Explosion-Protected Camera
Connections | en
23
6. For analog video models, connect the video coax cable with a male BNC connector to
terminal 7.
Note: A UTP adapter (VDA-455UTP) is available as an optional accessory to allow a UTP video
cable to be connected to the BNC connector.
For fiber optic video models, connect a terminated fiber optic cable to the female ST
connector.
If the optional OFC kit has been installed, connect a terminated fiber optic cable to the female
ST connector.
9. Clean and grease the O-ring and threads before replacing the end cap. Refer to Installation
10. Replace the end cap.
11. Tighten the end cap using the multi-use tool. Ensure that the O-ring is properly seated.
After tightening, ensure that there is no gap between the cap and the body of the housing.
12. Tighten the set screws on the end cap using the supplied hex key.
Set screws must not protrude from the threaded hole after tightening.
See also
–
Installation Overview, page 18
–
Installation Overview, page 18
Bosch Security Systems, Inc.
Installation Manual
2016.03 | 1.0 | F.01U.318.222
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
