10.2
42
en | Maintenance
EX65 Explosion-Protected Camera
10
Maintenance
10.1
Repairs
Danger!
Disconnect power before servicing or disassembling the housing or unit.
Never remove the front or end caps unless power is disconnected from the unit.
!
Caution!
The camera itself does not contain any user-serviceable parts. Ensure that all maintenance or
repair work is performed only by qualified personnel. If in doubt, contact your dealer's
technical service center.
The unit has some user-serviceable parts, including the camera and lens. These parts are
available as spare parts. Please contact your local service center for information about
obtaining these parts.
Removal of the Camera and Lens
1. Remove the sliding camera tray as shown in steps 1- 3 of Configuration, page 24.
Figure 10.1: Camera pulled from housing
1
Inner mounting bracket assembly
2
DINION camera
3
DINION menu buttons
2. Remove all connections at the back of the camera.
3. Locate the mounting bolt for the camera on the bottom of the sliding tray and remove the
bolt with a #3 Phillips screwdriver.
4. Remove the camera from the mounting tray.
5. Remove the lens from the camera.
Installation of the Camera and Lens
1.
Install a new lens onto the camera.
2.
Ensure that the camera and the lens are directed to the front and are parallel to the
sliding tray.
3.
Reinstall the mounting bolt with a #3 Phillips screwdriver. Tighten the camera mounting
bolt to 4.5 N m (3.3 ft/lb).
2016.03 | 1.0 | F.01U.318.222
Installation Manual
Bosch Security Systems, Inc.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
10.3