UML-190-90
Navigating the Monitor | en
16
Bosch Security Systems, Inc.
Installation Manual
F01U075712 | 1.0 | 2007.09
6.2
Navigating the Monitor On-screen Display (OSD)
The UML-190-90 has two (2) modes, Video and VGA. The UML-190-90 is programmed through
the on-screen display (OSD) menus. Each on-screen display (OSD) shows a list of parameters
or submenus that can be selected by the operator. To access the OSD menus, press the Menu
button. Use the front panel of the UML-190-90 to make any necessary adjustments to the
OSD. To navigate the set up menus, follow the steps below:
1.
Connect the CVBS or VGA cable.
2.
If required, press the Input button until a signal is displayed. NOTE: Menus are not avail-
able without a signal applied.
3.
Power on the unit by pressing the power button (see
Figure 6.1
on page 15).
4.
Press the Menu button to activate the main menu selections (see
Figure 6.1
on page 15).
5.
Press the
and
buttons to navigate in selecting a main menu.
6.
Press the Menu button to enter into the selected main menu.
7.
Press the
and
button to toggle the OSD values.
When finished, scroll to Exit and press the Menu button. NOTE: If there is no Exit button,
press the Menu button.
