Final assembly
Camera operation
!
Warning!
Hazardous voltage
Use caution when working inside the housing. Hazardous voltage is present in the housing
when connected to the AC supply. Do not touch the power terminals when the unit is
powered.
Verify operation of the camera and lens before final assembly. Adjust the camera orientation,
focal length (if applicable) and focus as necessary (refer to the camera installation manual).
Closing the housing
!
Caution!
Always securely tighten all fittings to ensure a liquid-tight seal. Failure to do so could allow
water to enter the housing and damage the units. If a sealant is used, ensure that it is a
neutral cure type. Sealants that release acetic acid may harm electronics. Use drip loops on
the wiring outside the housing.
–
Pull any excess wire out of the housing and tighten the cable glands. The tightening force
required is approximately 1 to 1.5 turns past the point where the gland starts to grip the
wire. Failure to correctly tighten the glands could result in water ingress.
–
Ensure that all holes are covered with the rubber plugs provided.
–
Close the cover and secure the latches. Optional tamper-resistant screws are provided
with the housing. If desired, secure the latch using these three screws and the provided
tamper-resistant wrench.
3x
Close
Positioning sunshield
1.
Loosen the two screws (M4 x 10) on the top of the housing.
2.
Slide the sunshield to the desired position. It has a range of 50 mm (2 in).
3.
Tighten the screws to lock the sunshield into position.
4.
If the sunshield is not installed, seal the two screw holes with the plugs supplied.
2x
Sunshield
6.4
6.4.1
6.4.2
6.4.3
20
en | Connection
UHO Camera Housing
2014.10 | 5.0 | F.01U.167.418
Installation Manual
Bosch Security Systems
Summary of Contents for UHO-HBGS
Page 1: ...UHO Camera Housing UHO HBPS UHO HBGS UHO HGS UHO HPS en Installation Manual ...
Page 2: ......
Page 23: ......
