26
en | Installation
UHI/UHO Series
F.01U.026937 | V 2.0 | 2007.01
User Manual
Bosch Security Systems
4.
Install screws into the appropriate holes.
5.
Close the cover and secure the latches.
6.
Optional tamper-resistant screws are provided with the
housing. If desired, secure the latch using these three
screws and the provided tamper-resistant wrench.
4.12
Sunshield
1.
Loosen the two screws (M4 x 10) on the top of the hous-
ing.
2.
Slide the sunshield to the desired position. It has a range
of 50 mm (2 in).
3.
Tighten the screws to lock the sunshade into position.
4.
If the sunshield is removed or not installed, plug the two
screw holes with the hole plugs supplied with the housing
hardware kit.
4.13
Fuse replacement
1. To replace a fuse, pull the top of the fuse holder.
2. Replace the fuse with a fuse that has the same current rating.
The fuse is a 5 mm x 20 mm slow blow breaking capacity car-
tridge-type fuse.
NOTE!
There is a spare fuse inside the housing.
Camera voltage
Fuse rating
24 VAC
4 A, 250 VAC
120 VAC
2 A, 250 VAC
230 VAC
2 A, 250 VAC
Table 4.8
Specifications for replacement fuses
Summary of Contents for UHI-OG-0
Page 2: ......
Page 10: ...10 en UHI UHO Series docnumber V 2 0 2007 01 User Manual Bosch Security Systems ...
Page 31: ......
