Data subject to change without notice | Printed in the USA | BTC 722002312 A | 08.2021
Bosch Thermotechnology Corp.
Technical Service Bulletin
Tronic 5000C/6000C Polypropylene Heating Canister Replacement
| 9
12. Separate the two black canisters from each other by rotating at the joint to
disengage the connection, and then pulling them apart (Fig.41).
Figure 41
13. Ensure that the o-ring is in place on the existing right canister’s connector
pipe (Fig.42) and lubricate it with a small amount of silicone grease.
Figure 42
14. Connect the new left canister to the existing right canister and rotate to lock
into place (Fig.43).
Figure 43
15. Using the fi ve M4 fl ange nuts that were removed in Step 11, secure the
black polypropylene canisters back to the chassis’ threaded studs (Fig.44).
Figure 44
16. Heat sink paste was supplied with the new black polypropylene canister,
apply it to the brass element assembly cap at the three locations outlined
below (Fig.45).
Figure 45