14
Robert Bosch Hausgeräte GmbH
en
Water filter
A new water filter must be rinsed before it
can be used.
● To do this, press the water filter firmly
into the water tank
11
with the aid of the
measuring spoon
14
. Fill the water tank
with water up to the “
max
” mark.
●
Turn the rotary knob
6
to select
start
and press the
start
button
8
.
Place 1 l container
Place suction pipe in container
start
●
Place a container with a capacity of 1 litre
under the milk frother
10
.
●
Place the end of the suction pipe
10d
in
the container.
●
Press the
start
button
8
. Water will now
flow through the filter to rinse it.
● Next, empty the container.
The appliance is ready for use again.
Info:
Rinsing the filter simultaneously
activates the setting for the “change filter”
display.
You can find detailed information about the
water filter in the enclosed filter instructions.
The filter is no longer effective when the
Service - change filter
display appears, or
at the latest after two months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Replacement filters can be obtained from
retailers (TCZ7003) or from customer
service (575491).
If no new filter is used, turn the
Water filter
setting to
no
.
Info:
If the appliance has not been used for
a prolonged period (for example, when you
are on vacation), the existing filter should
be rinsed before the appliance is used
again. To do this, simply dispense a cup of
hot water.
Transport. lock
●
To avoid damage caused by frost during
transport and storage, the appliance must
be completely emptied first.
Info:
The appliance must be ready for use
and the water tank
11
filled.
●
Press the
start
button
8
. The appliance
automatically empties the pipe system
and switches off.
●
Empty the water tank
11
and the drip
tray
23
.
Factory reset
You can cancel your own settings and reset
the factory settings.
●
To activate the factory settings, press the
start
button
8
.
Info:
The appliance can also be reset to
the factory settings using a combination of
buttons. The appliance must be switched
off fully.
●
Hold down the selection buttons
<
and
>
4
and the on/off switch
1 O / I
at the same
time for at least 5 seconds. Press the
start
button
8
. The factory settings are
now reactivated.
Summary of Contents for TES?712 Series
Page 4: ...14 10c 10d C D E 23b 24 23c 23a 10c 10d 13 10a 10b ...
Page 5: ...F 20a 20a 20a 20b 20 21 19 22 ...
Page 165: ......
Page 166: ......
