NLAvoid material damage
m
Material damage
to avoid
avoid material damage
†Modified or damaged water
hoses can lead to material damage
and damage to the device.
▶
Never kink, pinch, modify or cut
water hoses.
▶
Only use supplied water hoses or
original spare hoses.
▶
Reuse never used water
hoses.
†Too low or too high water pressure
may interfere with the device function.
▶
Make sure that the water
pressure at the water supply
system is a minimum of 50 kPa
(0.5 bar) and a maximum of 1000
kPa (10 bar).
▶
If the water pressure exceeds the
specified maximum value, a
pressure reducing valve must be
installed between the drinking
water connection and the hose
set of the device.
Avoid material damage
Safe installation
PAY ATTENTION!
†An improper installation of
the device may cause damage.
▶
If the dishwasher is installed
below or above other household
appliances, the information on
installation in conjunction with
the dishwasher in the installation
instructions for the respective
household appliance must be
observed.
▶
If no information is available or
if the installation manual does
not contain any instructions on
this subject, please check with
the manufacturer of these
household appliances whether
the dishwasher can be built in
above or below other household
appliances.
▶
If no information from the
manufacturer is available, the
dishwasher should not be
installed above or below these
household appliances.
▶
To ensure safe operation of all
household appliances, you must
also continue to follow the
installation instructions for the
dishwasher.
▶
Do not install the dishwasher
under a hob.
▶
Do not install the dishwasher
near heat sources such as a
radiator, water heater, stove or
other appliances that give off
heat.
Safe use
PAY ATTENTION!
†Emerging water vapor
can damage built-in furniture.
▶
After the program has ended,
allow the appliance to cool down
for a while before opening the
appliance door.
†The rinse aid container can be
softening salt for dishwashers
corrode.
▶
To ensure that spilled softening
salt is rinsed from the rinse aid
container, the softening salt must
be filled into the softening salt
reservoir immediately before the
program starts.
10
