7
Linear Motion and Assembly Technologies
Bevel Length = 60mm
Bevel Length
Adjusting Stud
and Jam-Nut
4.
Bevel Length Adjustment
(Figures 6 and 7)
The belt grinder is preset to provide the correct
bevel length for TS
plus
conveyor transport belts,
which is 60mm (Figure 6).
If adjustment is needed, the slope of the table
can be increased or decreased to provide the
proper bevel length. Loosen the 7/16
″
jam-nut
on the bevel length adjustment setscrew under
the rear edge of the table. Then use a 1/8
″
hex
key to turn the setscrew. Turn it clockwise to
decrease the bevel length, counterclockwise to
lengthen the bevel length. Once the bevel length
is set to the correct 60mm length, hold the
setscrew in place with the hex key and tighten
the jam-nut securely.
5.
Final check
Make sure that all guards are in place and all
fasteners are tightened securely before using the
belt grinder. Be certain the power switch is in the
OFF position before plugging in the cord.
The belt grinder should be securely clamped
or fastened to a solid, stable worksurface that
is clean and free of items that could present
a hazard.
Fig. 6
Fig. 7
