11
Linear Motion and Assembly Technologies
6. Peel the backing from the end of the new
abrasive cover and attach it to the edge of
the drum, then slowly turn the drum clockwise,
installing the abrasive in a spiral direction, until
the entire drum is covered.
IMPORTANT:
Always install the new abrasive
cover in the same spiral as the old one! Failure to
do so could cause the abrasive to become loose
or cause poor results.
7. Once the drum is covered, trim any excess
abrasive paper that extends past the ends of
the drum.
8. Recheck the zero-point setting, following the
instructions on page 6, and adjust as needed.
9. Reinstall the aluminum guard and tighten the
nuts securely. NEVER operate the belt grinder
without all guards in place.
