Bosch Rexroth CytroPac, Operating Instructions Manual, Page: 26 / 84

26/84 Transport and storage
Bosch Rexroth AG , CytroPac, RE 51055-B/06.17
CAUTION
Heavy loads with a weight of more than 15 kg!
Risk of injury! Risk of health hazards! Damage to property!
▶ Use a forklift or suitable lifting gear e.g. lifting slings or lifting straps to
transport the hydraulic power unit.
▶ During transport, secure the hydraulic power unit against falling.
▶ Carefully position the hydraulic power unit on the contact surface to prevent any
damage.
6.1.1 Preparing for transport
Prior to transport, make the following preparations:
▶ Check the space required for installation of the hydraulic power unit at the place
of use.
▶ Check the transport route.
▶ Depending on the type of transport, ensure additional space besides and over the
hydraulic power unit.
▶ For transportation after operation, drain the hydraulic fluid from the oil tank.
To prevent air in the suction line, a low level of hydraulic fluid is always inside the
tank.
6.1.2 Transport using forklifts and similar floor conveyors
To transport the hydraulic power unit using a forklift, proceed as follows:
1. Move the fork of the forklift under the packaging of the hydraulic power unit or
under the hydraulic power unit secured for transport.
2. Carefully lift the load for checking the center of gravity position. Ensure a stable
center of gravity position.
3. Make sure that the hydraulic power unit cannot move out of the intended
position.
4. Secure the hydraulic power unit against the occurring acceleration forces and the
related undesired motion of the hydraulic power unit.
5. During transport, only lift the hydraulic power unit as far off the floor as
necessary for transport.
Fig. 4: Transport using a forklift
Transport after previous
operation
S S