RE 91485-01-B/2021-11-18, Bosch Rexroth AG
Removal and replacement |
A10FZO/G, A10VZO/G
61
/72
11 Removal and replacement
11�1 Required tools
Removal can be performed using standard tools. No special tools are necessary.
11�2 Preparing for removal
1�
Decommission the relevant system part as described in the instruction manual
for the machine or system.
– Relieve pressure in the hydraulic system according to the instructions of the
machine or system manufacturer.
– Make sure the relevant machine/system components are depressurized and
de-energized.
2�
Secure the relevant system part against reactivation.
11�3 Performing the removal
Proceed as follows to remove the axial piston unit:
1�
Make sure you have the appropriate tools and wear personal protective
equipment.
2�
Allow the axial piston unit to cool down until it can be removed without
danger.
3�
For below-reservoir installation, before removing the axial piston unit,
seal the connection to the reservoir and/or drain the reservoir.
4�
Place a drip tray under the axial piston unit to collect any hydraulic fluid that
may leak.
5�
Disconnect the lines and collect the escaping hydraulic fluid in the drip tray.
6�
Remove the axial piston unit. Use a suitable lifting device.
7�
Completely drain the axial piston unit.
8�
Plug all openings.
11�4 Preparing the components for storage or further use
▶ Proceed as described in chapter 6.2 "Storing the axial piston unit" on page
28.
