Bosch R911274804, Project Planning Manual

Page: 64 / 76

MKE
11-6
Mounting and Installation DOK-MOTOR*-MKE*******-PRJ1-EN-E1,44
•
06.97
Fig. 11-4: Feeding in power and feedback cables of MKE 096
⇒
Pull cables back to the point where the shrink sleeve extends into the
interior of the terminal box starting from the end of the screwed joint
for a length of about 35 mm (up to about the middle of the terminal box
lid) (see Fig. 11-4: Feeding in power and feedback cables of MKE
096).
⇒
Screw down cap nut (5) onto screwed joint (2) with a tightening torque
of about 15 Nm. This torque is achieved if the cable screwed joint is
manually tightened and then turned twice using a suitable tool.
⇒
The connectors X1, X2 and X3 must be mounted as per MKE motor
plans (see Fig. 3-2: Terminal diagram of MKE motor with terminal
box).
Note: Crimping pliers are available from INDRAMAT to mounting
connector X3, part no. 262 293
⇒
The ground ring terminals (10) and (11) must be screwed to the termi-
nal box lid (9) with 1.3 Nm.
⇒
X1, X2 and feedback connector X3 must be placed into position on the
motor mounting panel.
⇒
The 4 connecting screws (plugin bushing of power cable connector
part no.: 259698) of X1, must be firmly screwed into place.
⇒
The sealing ring (12) must be well greased and inserted into nut on
motor housing (13).
⇒
Make sure that no cable strands are pinched or damaged.
⇒
Tighten terminal box lid (9) into place with TFL coated lid screws (8)
and 6.1 Nm.
If the lid screws (8) must be replaced, then use only screws, as per
DIN 912 with a firmness of at least 8.8!
Note: If the terminal box is repeatedly mount, then it is recommen-
ded that the screws (8) are additionally secured with Loctite
243.